Page 1 of 1

Saved camera position changes between jumps

Posted: 11 May 2013, 12:00
by MJumper
So, I was playing around with the free camera this morning and something odd happened:

I used the ctrl+v -mode to move the camera in F3 view (which I had previously modified to a kind of hybrid of F2 and F3). I liked the new angle so I saved it, which seemed to work.
However, after jumping a few times with F12 view, I noticed that the F3 got messed up somehow. Now, every time I finish a jump with anything else than F3, the next time I start a jump in F3 the camera is not the way I saved it.

I thought it had to do with saving in ctrl+v mode so I changed F3 back to default view and saved. Still, the camera keeps moving to another position every time I go to F3. If I finish a jump in F3, it goes temporarily back to normal, until I change to any other camera again. Here's a picture:
Image.

So, is this a bug or am I just doing something wrong? It's not that bad but it's a little annoying since I have now one less usable camera.

Re: Saved camera position changes between jumps

Posted: 11 May 2013, 12:28
by Jussi Koskela
Confirmed. The problem is present only in the F3 view. I'll fix it.

Re: Saved camera position changes between jumps

Posted: 11 May 2013, 14:14
by Maciejo-96
I have got quite similar problem.
Here is the screen after start from F3 camera:
http://postimg.org/image/n38tje20n/
I changed camera to F1. After about 2 seconds, I changed to F3 and I had got that view:
http://postimg.org/image/52zmf09tj/

Re: Saved camera position changes between jumps

Posted: 13 May 2013, 15:53
by Jussi Koskela
Bug fixed. A patch will probably be available tomorrow.

Re: Saved camera position changes between jumps

Posted: 14 May 2013, 15:58
by Jussi Koskela